Dynalink RTA770W Einstellungsanleitung PDF herunterladen (Seite 16)

If (A) fails but (B) shows a response, this is probably a DNS problem. Go to

Procedure (2) of Section 4. Enter the router’s IP (192.168.1.1) as DNS.

If both (A) & (B) show a response, your router is actually on line. The problem

may be with your browser setting. Try returning any custom settings of the

browser to default. If you have a personal firewall, disable it to see if it makes

any difference. Also you may try shutting down the computer and restarting.

Q3. Need to install router on a network that uses a different subnet

If the existing network already has a DHCP server, disconnect one computer from

the network. Connect the computer to the router. The host computer will be

assigned 192.168.1.2. You can change the router’s IP so that it is consistent with

the network. Disable DHCP on the router.

Q4. Browsing is fine but I cannot run certain applications.

You need to set up virtual servers or DMZ host. See Section 7 on Firewall & traffic

restrictions.

Q5. The router’s IP and/or administrative password have been modified. But

the details have now been forgotten.

You can restore the router to factory default by pushing a pin into the hidden

reset button located next to the power on/off button at the back of the router.

Push and hold for 5 seconds then release to reset router.

Q6. I need to know the dynamically assigned WAN IP when the router

goes on line

Go to Status > Internet Connection, the WAN IP is displayed here.

Q7. How to find the MAC addresses of wireless clients

If the wireless client has not been installed, follow the vendor’s instructions to

find the device’s MAC address. Often it is printed on a label affixed to the device.

ADSL Router Quick Set-up Guide

1 2 ... 11 12 13 14 15 16 17 18

Keine Kommentare

Dynalink RTA770W Einstellungsanleitung Seite 16