Dynalink RTA770W Einstellungsanleitung PDF herunterladen (Seite 5)

Get your computer ready for networking

The description below assumes you are connecting the router via Ethernet. If

you are connecting the router via USB, refer to Chapter 2 - USB Driver Installation

on page 4 of the User’s Manual on CD.

You have two options. Following option (1) is simplest. This is the Windows

default network setting.

OPTION 1. CONFIGURE COMPUTER TO GET IP ADDRESS FROM DHCP

If your computer is already configured to obtain an IP address automatically

(from a DHCP server), do nothing. By default the router is a DHCP server. Now

go to Section 5 – Getting On-Line.

If you are unsure of your computer’s network setting refer to Chapter 3 – Configure

PC to get IP address from DHCP on page 18 of the User’s Manual.

OPTION 2. MANUALLY ASSIGN IP ADDRESS TO COMPUTER

The router’s default address is 192.168.1.1. If you prefer to assign an IP address

manually, use 192.168.1.x (x is a number between 2 and 254).

Windows XP/2000:

1. Go to Control Panel – Network

Connections. Open Local Area

Connections and click Properties.

Double click Internet Protocol

(TCP/IP). Select Use the following

IP address.

2. Enter 192.168.1.x (x is a number you

pick between 2 and 254). This is the

IP address you assign to the

computer. Subnet Mask is

255.255.255.0.

3. Enter the router’s IP 192.168.1.1 as

Default gateway, and as Preferred

DNS server If your ISP specifies DNS

server addresses, enter the specified

addresses according to the ISP’s instructions.

4. Click OK to finish.

You have now finished with configuring your computer.

1 2 3 4 5 6 7 8 9 10 ... 17 18

Keine Kommentare

Dynalink RTA770W Einstellungsanleitung Seite 5