Dynalink RTA770W Einstellungsanleitung PDF herunterladen (Seite 3)

Default Configuration for New Zealand

This router is shipped with the following factory default settings.

Router IP address 192.168.1.1

Subnet mask 255.255.255.0

VPI 0

VCI 100

Connect mode PPPoA VC-MUX

NAT enabled

DSL line mode auto select G.DMT / T1.413

WAN IP dynamic

DHCP enabled

DNS relay on

UPnP IGD enabled

Firewall incoming on

Firewall outgoing off

Router configuration & management:

User name admin

Password admin

Telnet password admin

If your ISP specifies that your ADSL service is PPPoE, connect mode must be

changed to PPPoE LLC/SNAP. Instructions will follow. Check with your ISP if

you are unsure of the type of service you have subscribed to. Advanced users

who have other setup preferences should first read the User’s Manual.

Before you start

Make sure your computer has these installed:

Ethernet or USB port

TCP/IP protocol enabled

A web browser, Internet Explorer 5.0/Netscape 6 or better.

Obtain your Internet account information from your ISP:

Public IP address (only if you subscribe for static IP)

DNS server IP (only if specified by ISP).

1 2 3 4 5 6 7 8 ... 17 18

Keine Kommentare

Dynalink RTA770W Einstellungsanleitung Seite 3