Dynalink RTA210 Einstellungsanleitung

Quick Setup GuideRTA210ADSL Router

Indicator lightsThere are four green indicats on the front panel of the router. All lights will comeon indicating self-test in progress every time the

Scroll down to Data Encapulation.Click on the selection box, change Bridge to PPP0A:Remember to click Submit to take effect and then go to Tool > S

ping 192.168.1.1 then press Enter. The response should be:Pinging 192.168.1.1 with 32 bytes of data:Reply from 192.168.1.1: bytes=32 time=4ms TTL=30If

perform a PING test as described in Q1-3, using these addresses:(A) Ping www.dynalink.co.nz (or any valid web address)(B) Ping 205.178.180.16 (or any

Dynalink Modems Ltd warrants this product against defects in materials andworkmanship for a period of twelve months from the original date of purchase

ImportantThis Guide is intended to get you started quickly.We have pre-configured the router for the New ZealandADSL network. All you need to do is to

Default Configuration for New ZealandWe have pre-configured this router to the following settings. If you accept thesettings, please move on to Sectio

STEP 1 CONNECT IT UPFor a step-by-step guide refer to Page 5 Chapter 2 Hardware Description &Installation of the ADSL Router User Manual on CDRom.

Select DNS Configuration tab, clickEnable DNS. Type in any name forhost. Enter your ISP’s DNS address.Click Add. A second DNS address(if specified) ca

For Windows XP/2000:From Control Panel - Network Connections. Open Local Area Connectionsand click Properties. Double click Internet Protocol (TCP/IP)

ADSL Router Quick Set-up GuideSTEP 4 ENTER INTERNET ACCOUNT USER NAME AND PASSWORDGo to Configuration > WAN > ATM PVC > Setup ATM PVC. The p

STEP 5 SAVE CONFIGURATION AND CHECK IF THE ROUTER IS ONLINEGo to Tool > Save Configuration. Click on Save. Next go to Tool > Reset Router.Make

DHCP:Configure PC to get IP from DHCP Page 32 Section 4.2Enable DHCP Page 43 Section 6.2.2Show DHCP table Page 70 Section 6.5.6Use the Web Configurati